Removal 1.Disconnect the battery cable negative terminal. 2.Drain the engine coolant. 3.Remove the engine cover.(Non-tilt cab model only) 4.Remove tne...
Installation 1.ApplyLoctite262 or equivalent or equivalent to the threaded portion ofthe engine coolant temperature sensor and tighten at the specified...
Removal 1.Disconnect the battery cable negative terminal. 2.Drain the engine coolant. 3.Open the engine cover.(Non-tilt cab model only) 4.Disconnedt the...
1.Installthe water pump assembly ·Set O-ring in water pump body groove. Install water pump assembly,and tighten to specified torque. Tightening...
Removal 1.Disconnedt the battery cable negative terminal. 2.Drain the engine coolant. 3.Remove the engine cover.(Non-tilt cab model only) 4.Remove the...
Removal 1.Disconnect the battery cable negative terminal. 2.Open the engine cover.(Non-tilt cab model only) 3.Disconned the camshaft position sensor connector....
1.Install the crankshaft gear. a.Install the crankshaft gear. b.Use the crankshaft gear installer(1)to install the crankshaft gear(2). The crankshaft gear timing mark(“.-·”)must be facing outward. Special tool: Crankshaft Gear Installer:9-8522-0020-0 2.Install the camshaft timing gear. a.Install the thrust plate to the cylinder body. b.Tighten the thrust plate bolts to the specified torque. Tightening torque: 19 N·m(1.9 kg·m/14 Ib·ft) c.Install the camshaft timing gear to the camshaft. The timing gear...
Removal 1.Disconnect the battery cable negative terminal. 2.Drain the coolant. 3.Remove the radiator. Refer to “Radiator”in Section 6B Engine Cooling....
Legend 1.Fan shroud 4.Lock bolt 2.Fan belt 5.AC generator fixing bolt 3.Support rubber Removal 1.Disconnect the battery cable negative terminal. 2.Drain the engine coolant. 3.Remove the cab.(Non-tilt cab model only) Refer to “FRAME AND CAB”Section 2. 4.Remove the fan shroud. ·Remove reservoir tank hose and fan shroud. 5.Removethefanbelt. Remove adjust plate...
Condition Possible Cause Correction Improper fuel injection timing Engine control system problem Diagnose engine control system. Refer to “Diagnostic Information and Procedures”in Section 6E,Engine Control System Error detected by...