How to remove and install the ISUZU 4JH1 ENGINE Camshaft Position Sensor

Removal
1.Disconnect the battery cable negative terminal.
2.Open the engine cover.(Non-tilt cab model only)

3.Disconned
the
camshaft
position
sensor
connector.
4.Remove the camshat position sens

Installation
1.Install the camshaft position sensor and tighten at
the specified torque.
Tightening torque:
8Nm(0.8kg-m/69
Ib-in)

2.Connect the camshatt position sensor connector.
3.Close the engine cover.(Non-tilt cab model only)

4.Connect  the  battery  cable  negative  terminal.