Importance of changing the oil during the first maintenance of Deutz diesel engine

Importance of the first maintenance of Deutz diesel engine

Oil change cycle and oil level check Place the engine and vehicle in a horizontal position, run at idle speed for 2 minutes before checking the oil level, and then stop.

 Deutz Diagnostic Tool Communicator for Deutz Engine DECOM Controllers

Check the oil level and add oil to “Max” if necessary. If the oil level is only slightly above the “Min” minimum scale, oil must be added

The oil level must be between the upper and lower lines of the dipstick. 

 If the oil level is too low, it will cause serious damage to the engine.   

The oil must be changed during the first maintenance of a new car, and the oil should be changed every 10,000 km thereafter.

Excessive oil level will cause:

 *Oil overflow. 

*Increased oil temperature. 

 *Foam. *Increased air content in the oil leads to bearing damage. 

Deutz Serpic 2012 EPC Download & Installation Service Finial Version
  Lack of oil leads to bearing damage

Running the engine with insufficient oil will cause bearing damage due to lack of oil. 

*The leftmost bearing shows typical tin plating friction marks on the bearing. 

 * The connecting rod bearing shown in the middle is worn out later, and a melted metal dot can be seen    on the lead-copper layer

 * The metal dot is found embedded in the tin layer of the main bearing shown on the right 

* All the above bearings are from the same engine and cannot be repaired. 

Connecting rod bearing cap broken due to lack of oil: