Compressor Drive Belt – Adjusting

1

Park the machine on firm level ground. Raise and block

JCB Electronic Service Tool Diagnostic Kit High Quality

the loader arms. Lower the backhoe to the ground and

stop the engine.

2

Remove the starter key.

! WARNING

Make sure the engine cannot be started. Disconnect the

battery before doing this job.

2-3-3-5

3

Raise the Bonnet

4

Remove both Side Panels

5

Loosen pivot fastening bolt A. Loosen adjustment link

fastening bolts B and C.

6

Position the compressor so that there is approximately

10 mm (3/8 in) slack at point X midway along the belt.

7

Tighten bolts A, B and C. Make sure that bolt A is the

JCB ServiceMaster/WinEEM4 KG v2 Keygen

last to be tightened.

Note: If a new belt is fitted, check the belt tension after the

first 20 hours of operation.

Section B

Body & Framework

9803/3280

Section B

20 – 10

Issue 1

Service Procedures

S209393

X

A

B

C

03.2026 JCB ServiceMaster 4 v26.3.2 Diagnostic Software with SW Files Download and installation